A study of foaming of rubber
6
item.page.dc.date.issued
2023
item.page.dc.date.copyright
1992
item.page.dc.language.iso
eng
item.page.dc.format.mimetype
application/pdf
item.page.dc.format.extent
xii, 103 leaves : ill.
item.page.dcterms.accessRights
restricted access
item.page.dc.rights.holder
Mahidol University
item.page.dc.identifier.citation
Thesis (M.Sc. (Polymer Science))--Mahidol University, 1992
punsarn.item.page.citation
Sombat Thanawan A study of foaming of rubber. Thesis (M.Sc. (Polymer Science))--Mahidol University, 1992. Retrieved from: https://repository.li.mahidol.ac.th/handle/123456789/90529
item.page.dc.title
A study of foaming of rubber
item.page.dc.title.alternative
การศึกษาการโฟมยาง
item.page.dc.contributor.author
item.page.dc.contributor.advisor
item.page.dc.description.abstract
Studies were made of various factors affecting the structures and properties of rubber foams. The objectives were to establish the production and control technologies for the manufacturing of good quality rubber foams, in particular the ethylene vinyl acetate rubber (EVA) foams. The method of control of mixing was established by using the combination of light microscopy and monitoring the power consumption during mixing. This enabled optimization of mixing to be made. The EVA compounds for foaming were best prepared by sheeting the compounds to ca. 1 mm. thickness and cooled normally in air at room temperature. These EVA compound sheets could be stored for up to 5 days before being foamed without causing any deleterious effect on the properties of the foams. Oscillating disc rheometer (ODR) could be used to control the quality of EVA compounds for foaming. The properties of the foams were greatly affected by the relative rates between the blow rate of the blowing agent and the cure rate of the rubber, the amounts of blowing and curing agents used but the heating time of the compound in the press had relatively little effect on the properties of the foams. For occur, the blow rate of the blowing agent must be shorter than the cure rate of the rubber.
item.page.thesis.degree.name
Master of Science
item.page.thesis.degree.level
Master's degree
item.page.thesis.degree.department
Faculty of Science
item.page.thesis.degree.discipline
Polymer Science
item.page.thesis.degree.grantor
Mahidol University
