Personalized Ti6Al4V implant abutment fabricated by hybrid laser powder bed fusion process: Mechanical and microstructural perspectives
5
Issued Date
2026-05-01
Resource Type
ISSN
22387854
eISSN
22140697
Scopus ID
2-s2.0-105037406082
Journal Title
Journal of Materials Research and Technology
Volume
42
Start Page
5223
End Page
5233
Rights Holder(s)
SCOPUS
Bibliographic Citation
Journal of Materials Research and Technology Vol.42 (2026) , 5223-5233
Suggested Citation
Promoppatum P., Soe A.N., Maneein M., Chayasombat B., Khamlue P., Srimaneepong V., Urapepon S., Lee D.H., Poovarodom P. Personalized Ti6Al4V implant abutment fabricated by hybrid laser powder bed fusion process: Mechanical and microstructural perspectives. Journal of Materials Research and Technology Vol.42 (2026) , 5223-5233. 5233. doi:10.1016/j.jmrt.2026.04.162 Retrieved from: https://repository.li.mahidol.ac.th/handle/123456789/116558
Title
Personalized Ti6Al4V implant abutment fabricated by hybrid laser powder bed fusion process: Mechanical and microstructural perspectives
Corresponding Author(s)
Other Contributor(s)
Abstract
This study investigates the mechanical and microstructural characteristics of customized Ti6Al4V dental abutments fabricated using a hybrid laser powder bed fusion (LPBF) process combined with a machined titanium preform. Customized anterior and posterior abutments were designed and produced. Internal defects were evaluated using high-resolution X-ray micro-computed tomography (micro-CT), while microstructural analysis employed scanning electron microscopy (SEM), electron probe microanalysis (EPMA), and electron backscatter diffraction (EBSD). Hardness distributions were measured across the LPBF region, heat-affected zone (HAZ), and preform substrate. Micro-CT revealed low porosity levels in both geometries, with void fractions of 0.045% in anterior and 0.019% in posterior abutments, and mean pore diameters of 23.2 μm and 25.8 μm, respectively. SEM confirmed a continuous metallurgical bond at the preform interface without visible cracking or delamination, while EBSD identified three distinct zones, which are fine acicular α′ martensite in the LPBF region, transitional HAZ, and equiaxed α+β grains in the preform substrate. EPMA mapping indicated vanadium heterogeneity within the preform substrate and a more homogenized vanadium distribution in the fusion zone. Microhardness testing showed gradient values from 415 HV in the LPBF zone to 360 HV in the preform, with the HAZ averaging approximately 370 HV. The present findings reveal a strong metallurgical bond between the preform substrate and the LPBF region, demonstrating the potential use of the LPBF process for personalized implant abutments.