Tensile Property Enhancement by Laying the Continuous Carbon Fiber During 3D Printing Process
4
Issued Date
2025-01-01
Resource Type
ISSN
02555476
eISSN
16629752
DOI
Scopus ID
2-s2.0-105008763774
Journal Title
Materials Science Forum
Volume
1150
Start Page
21
End Page
26
Rights Holder(s)
SCOPUS
Bibliographic Citation
Materials Science Forum Vol.1150 (2025) , 21-26
Suggested Citation
Rattanapreechachai W., Chansoda K., Chookaew W. Tensile Property Enhancement by Laying the Continuous Carbon Fiber During 3D Printing Process. Materials Science Forum Vol.1150 (2025) , 21-26. 26. doi:10.4028/p-6PsdVW Retrieved from: https://repository.li.mahidol.ac.th/handle/123456789/110963
Title
Tensile Property Enhancement by Laying the Continuous Carbon Fiber During 3D Printing Process
Author(s)
Author's Affiliation
Corresponding Author(s)
Other Contributor(s)
Abstract
Fused Deposition Modeling (FDM) is widely used in additive manufacturing. The main limitations of 3-Dimentisonal (3D) printing are the expansive cost of the material and its low strength as compared to the traditional molding process. The supported material was more expensive because of the extrusion process. The high surface roughness in the nature of 3D printed objects is the principal reason for mechanical property weakness. To eliminate such problems, a pellet-based 3D printer coupled with the layup fiber technique was introduced in this preliminary study. The obtained result indicated that the sample produced by the pellet-based printer had the highest mechanical strength in the machine direction. A reduction in tensile strength was found at another raster angle. After considering the differences between carbon fiber (CF) formats, it was found that chopped fiber was ineffective in terms of printed strength. At the same time, the layup fabric type and continuous fiber could promote better mechanical properties. When analyzing the ratio of maximum strength/fiber weight, it should be noted that continuous fiber presented the highest reinforced efficiency.