Publication: Assessment of corrosion behavior in artificial saliva of wires for orthodontic applications
Issued Date
2018-01-01
Resource Type
ISSN
02555476
Other identifier(s)
2-s2.0-85045310423
Rights
Mahidol University
Rights Holder(s)
SCOPUS
Bibliographic Citation
Materials Science Forum. Vol.917 MSF, (2018), 197-201
Suggested Citation
Aphinan Phukaoluan, Anak Khantachawana, Pongpan Kaewtatip, Surachai Dechkunakorn Assessment of corrosion behavior in artificial saliva of wires for orthodontic applications. Materials Science Forum. Vol.917 MSF, (2018), 197-201. doi:10.4028/www.scientific.net/MSF.917.197 Retrieved from: https://repository.li.mahidol.ac.th/handle/20.500.14594/45848
Research Projects
Organizational Units
Authors
Journal Issue
Thesis
Title
Assessment of corrosion behavior in artificial saliva of wires for orthodontic applications
Other Contributor(s)
Abstract
© 2018 Trans Tech Publications, Switzerland. The aim of this study, the corrosion behavior of TiNiCu in artificial saliva (pH5.35) at 37oC was assessed by the use of electrochemical methods. Ti50Ni43Cu7(at%) used in this study were made from ingots prepared by the vacuum arc melting (VAM) method. The furnace was purged with argon gas during melting. All melted ingots were then homogenized at 800oC for 3.6 ks. Open circuit potential (OCP) was monitored at 3.6 ks followed by potentiodynamic techniques. The results showed that all chemical composition of orthodontic wires by EPMA were Ti, Ni, Cu, Cr, Fe and Mn. Surface roughness was measured in order to ensure that TiNiCu and SS was significant difference which might affect corrosion resistance. It was seen that TiNiCu orthodontic wires, presented a good corrosion resistance, compared to the stainless steel, probably due to the formation of a protective oxide film mainly constituted by titanium oxide.