Publication: The influence of blade type and feeding force during resin bonded dentin specimen preparation on the microtensile bond strength test
Issued Date
2021-01-01
Resource Type
ISSN
2072666X
Other identifier(s)
2-s2.0-85105141427
Rights
Mahidol University
Rights Holder(s)
SCOPUS
Bibliographic Citation
Micromachines. Vol.12, No.4 (2021)
Suggested Citation
Apinya Limvisitsakul, Suppason Thitthaweerat, Pisol Senawongse The influence of blade type and feeding force during resin bonded dentin specimen preparation on the microtensile bond strength test. Micromachines. Vol.12, No.4 (2021). doi:10.3390/mi12040450 Retrieved from: https://repository.li.mahidol.ac.th/handle/20.500.14594/76985
Research Projects
Organizational Units
Authors
Journal Issue
Thesis
Title
The influence of blade type and feeding force during resin bonded dentin specimen preparation on the microtensile bond strength test
Other Contributor(s)
Abstract
This paper presents the effect of blade type and feeding force during resin-bonded dentin specimen preparation on the microtensile bond strength (µTBS) test. Forty resin-bonded flat middle dentin specimens were divided into four groups. The specimens of each group were sectioned according to type of blade and feeding force as follows: fine grit/20 N, fine grit/40 N, medium grit/20 N, and medium grit/40 N to obtain resin-dentin sticks with a cross-sectional area of 1.0 mm2 . Four sticks from the center of each tooth were subjected to the µTBS test. Five remaining sticks of each group were selected for surface topography observation under a scanning electron microscope (SEM). As a result, the bond strength of the medium-grit group was higher than that of the fine-grit group (p < 0.001), whereas the feeding force had no influence on bond strength values (p = 0.648). From the SEM, sticks prepared with the fine-grit blade showed a smoother surface integrity and fewer defects on the specimen edges in comparison with the sticks prepared with the medium-grit blade. The grit type of the blade is one of the considerable factors that may affect the bond strength and the surface integrity of resin-dentin specimens for microtensile testing.